JAHNS  OIL FLOW DIVIDER

GEAR OIL FLOW DIVIDER MTO IN CAST IRON DESIGN

TWO TO TWELVE DIVIDERS

In the version with end position compensation with inlet and outlet blocks made of aluminum (EA7) or steel (EA9), in contrast to the G/S version, pressure relief and anti-cavitation valves as well as measuring connections are integrated for each section.

JAHNS OIL FLOW DIVIDER

GEAR OIL FLOW DIVIDER HTO IN CAST IRON DESIGN WITH INTEGRATED VALVES

TWO TO TWELVE DIVIDERS

In addition to achieving higher working pressures (up to 320 bar), the goal when developing this series was also to integrate the input and output blocks attached to the MTOs. 

Furthermore, the components have been optimized in such a way that the displacement range of the MTO assembly 3 can be covered with just two instead of four sizes. 

The HTO is only available in the version with end position compensation. The pressure relief and anti-cavitation valves as well as measuring connections are integrated in the housing for each section

JAHNS OIL FLOW DIVIDER

RADIAL PISTON OIL FLOW DIVIDER MT-GM

TWO OR THREE DIVIDERS

Based on coupled radial piston engines.

In the version with end position compensation FEA, in contrast to the version FG, pressure relief and anti-cavitation valves as well as measuring connections are integrated for each section.

JAHNS OIL FLOW DIVIDER

RADIAL PISTON OIL FLOW DIVIDER STL

TWO TO TWELVE DIVIDERS

In contrast to the S version, the version with end position compensation EA has integrated pressure relief and anti-cavitation valves as well as measuring connections for each section.

JAHNS OIL FLOW DIVIDER

PISTON FLOW DIVIDER VALVES MKA, MKS

TWO-WAY DIVIDER IN ALUMINUM OR STEEL

The oil flow divider valve works in both directions

OIL FLOW DIVIDER

SYNCHRONIZATION CONTROL BLOCK

DIVIDER

We would like to introduce you to our newly developed synchronization solution based on valve technology.

It is characterized by high synchronization accuracy, even with a wide variety of loads and small volume flows.

In addition, there are low requirements for installation space and low weight.

When compensating for the end position, there is no need for an after-suction function - in contrast to rotating dividers.

Please note that this synchronous solution is only suitable for double-acting cylinders connected on the rod side and, due to the valve technology, special attention must be paid to the cleanliness of the operating medium using filters with 10 µm.