Each component of the JMG (chamber, float, and indicator) has been engineered to improve on existing designs to ensure reliable, maintenance-free operation right out of the crate. The JMG can be coupled with an MGT magnetostrictive level transmitter and/or any Jogler level switch to provide control outputs configured to specific customer needs.

Utilizing the magnetostrictive principle and time-of-flight calculations allow the MGT-6000 to provide a fast and accurate measurement of float position and, ultimately, liquid level in the gauge. Vibration-isolating elastomeric bushings ensure continuous operation in high vibration services.

Utilizing the magnetostrictive principle and time-of-flight calculations allow the ILT-6000 to provide a fast and accurate measurement of float position and, ultimately, liquid level in the gauge. The ILT-6000 is installed in an isolation well assembly allowing the transmitter to be removed, serviced, or replaced with no process interruption.

Unique PTFE Teflon SuperSeals act as both the flange sealing face and sight tube seal so that only the Teflon and Borosilicate glass sight tube are wetted, pressure-bearing parts (Teflon lined models have only FEP as the wetted part).2 wire, loop powered (24VDC nominal)

• Powder-Coated Carbon Steel or 316/316L Stainless Steel shields

• Wide range of chemical compatibility

• 5 independent tube-sealing ridges for leak-free installations (7 for Tube-in-Tube models)

• FM approved for use with flammable liquids

Magnetic coupling through the chamber wall keeps these switches isolated from process fluid and pressure, allowing setpoints to be adjusted on the fly.

• No process piping or valves required

• Retrofit onto existing MLG installations

• Internal bias magnet maintains state in high-vibration environments

• Available in SPDT (one internal switch) or DPDT (two internal switches)

• Available with flying leads (no enclosure), Epoxy-coated Aluminum enclosure, or 316 Stainless Steel Enclosure

• Class I, Division 1, Groups B, C, D

• Class I, Division 2, Groups ABCD

• Class II and Class III, Groups EFG

• ATEX and IEC ratings (pending)

• Maintenance-free

Magnetic coupling through the chamber wall keeps the switch isolated from process fluid and pressure, allowing setpoints to be adjusted on the fly. Two JP-450’s can be coupled with a JPLR latching relay to give plug-and-play dump/fill valve control (see JP-450 data sheet).

• No process piping or valves required (except customer pneumatic lines)

• Retrofit onto existing MLG installations

• “Snap-action” design maintains state in high-vibration environments

• Accepts filtered air or gas supply

• Field configurable (High/Low level)

• 316 Stainless Steel enclosure​

4-20mA and relay outputs give the LLT-1000 the flexibility to be used in various control schemes.

• 4-wire transmitter (requires 24VDC)

• Non-contact measurement

• Narrow, accurate beam / long range (up to 330 ft)

• Visible aiming laser (optional)

• Dual compartment enclosure

• Custom mounting options

• Class I, Division 2, Groups A, B, C, D

• Class II and Class III, Groups E, F, G

• ATEX and IEC ratings (pending)

• Maintenance-free / Low cost-of-ownership