SCR Power Controller TC2000 Series

Eurotherm SCR Power Controller TC2000 Series TC2000 Two Leg Three Phase or Two Zone Single Phase Solid State Contactor SCR Power Controller For Resistive Load Features 500 amps Selectable firing modes Selectable input signal Optional load diagnostics The TC2000 series is available as a Solid State Contactor or an SCR Power Controller. Each can be configured to control three phase two-leg resistive loads (three-wire delta or wye) or two independent single phase resistive loads. The TC2000 can accept a logic input (AC or DC) or an analog or potentiometer input. The TC2000 is a compact back-panel mounted unit with a fold-down front door for easy configuration access. Units above 100 amp are fan cooled. Units are equipped with such protective features as high speed fuses with optional fuse failure microswitch, varistors, and grounded heat sinks. The TC2000 is insensitive to phase rotation of the supply and self synchronizes to the line frequency. It has a partial load unbalance sensing option with an alarm relay to annunciate a change in any leg of >10%. Type:TC2000/02/500A/440V/230V/4-20mA/000

 

 

Eurotherm SCR Güç Kontrol TC2000 Serisi TC2000 İki Bacak Trifaze veya İki Bölge Tek Fazlı Katı Hal Kontaktör Rezistif Yük için SCR Güç Kontrol Özellikler 500 amper modları ateş Seçilebilir giriş sinyali Seçilebilir Opsiyonel yük teşhis TC2000 serisi olarak kullanılabilir Solid State Kontaktör veya bir SCR Güç Kontrol. Her üç fazlı iki bacak rezistif yükler (üç telli üçgen veya wye) ya da iki bağımsız tek fazlı omik kontrol etmek için konfigüre edilebilir. TC2000 bir mantık girişi (AC veya DC) veya analog veya potansiyometre girişi kabul edebilir. TC2000 yapılandırma kolay erişim için bir kat aşağı ön kapı ile kompakt bir arka panel monte birim. 100 amper üzerinde Birimler fan soğutmalı. Birimler, isteğe bağlı sigorta arızası mikroswitch ile yüksek hızlı sigortalar, varistörler, ve topraklı ısı lavabo gibi koruyucu özellikleri ile donatılmıştır. TC2000 arz faz duyarsız ve kendini hat frekansı eşitler. >% 10 herhangi bir bacak bir değişiklik bildirmek için bir alarm rölesi ile kısmi yük dengesizliği algılama seçeneği vardır. Tip: TC2000/02/500A/440V/230V/4-20mA/000









 

  • SCR Power Controller TC2000 Series

    Eurotherm SCR Power Controller TC2000 Series eurotherm scr power controller tc2000 series tc2000 two leg three phase or two zone single phase solid...

  • Radio Remote Control

    ANALOGUE A command that can vary between the minimum and maximum value of a voltage or current. RECEIVING UNIT A device which, when connected to the machine to be controlled, decodes the digital data sequence and transforms it into electrical impulses which the machine needs in order to carry out the command selected by the operator on the portable transmitting unit TRANSMITTING UNIT A portable unit which communicates, to the receiving unit, the sequence of digital data that forms the command selected by the operator using the transmitting unit command devices (pushbuttons, selectors, joysticks). APPLICATION Sector where the radio remote control is used. ACTUATOR Electromechanical device which transforms a mechanical movement into an electric signal. COMMAND An individual instruction which must be given to the machine in order to carry out a single movement or task. FUNCTION A set of commands which carry out the same movement in its different directions or shifts. UNSTABLE A command which returns to its rest position. RANGE Maximum transmitting distance possible between the transmitting unit and its receiving unit. PROPORTIONAL A command that can vary between a minimum and a maximum voltage or current value according to the movement of an actuator. PWM Pulse Width Modulation. Modulation of the impulse width. This is the equipment control technique with proportional commands in current. RADIO REMOTE CONTROL Remote command that uses electromagnetic wave radio connection. SPARE PARTS Equipment parts that can be replaced through time. STABLE A command that remains in the position it is moved to. CABLE CONTROL Remote command connected via cable. CHARGE CONTROL Of a battery charger, the technology which allows control of the battery charge state. This guarantees optimum use. NiCd BATTERY Rechargeable batteries with Nickel-Cadmium cells. Standard charge capacity. NiMh BATTERY Rechargeable batteries with Nickel-Metal hydrate cells. High charge capacity.

ALFABETİK MARKA LİSTESİ

Sertifikalarımız

Oruçreis Mah. Tekstilkent Tic. Mrk.
G2 Blok, No:101 (10AD-Z77)
34235 Esenler / ISTANBUL
T: +90 212 235 95 35 / 36
F: +90 212 235 95 37

info@imajteknik.com

E-Bülten Listemize üye olun !

Gelişmelerden haberdan olmak ve ileride gerçekleştirilecek yeniliklerimizden haberdan olabilmek için e-posta adresinizi bizimle paylaşın!